contact us

CONTACT US

Quote Form

(###.###.####)

看不清,请点击我!

* If Quote is requested these Fields are Required.

A. Material

Thickest - Width x Thickness
Thinnest - Width x Thickness
Widest - Width x Thickness
Narrowest - Width x Thickness
Tensile PSI
Yield PSI
Shear PSI

B. Coils

  Lbs.
Minimum :
Maximum :
Minimum :
Maximum :
Lbs.
Lbs.

C. Press

Maximum SPM:
Minimum SPM: (Give Minimum SPM at which tonnage can be maintained.)

D. Dies

Maximum :
Minimum :
Maximum :
Minimum :

E. Application

Maximum :
Minimum :
  SPM at Inch Length
  Feet Per Minute

(as you face the press)

Length Width Deep

F. Equipment Desired

1. Servo Feed
2. Straightener
3. Stock Reel
4. Coil Loading Car
5. Coil Cradle
6. Coil Loading Ramp
7. Hold Down Peeler
8. Threading Table
9. Central Control Console
10. Straightener Feeder
11. Straightener Feeder
12. Cradle Straightener Feeder
13. Other - Describe

G. Plant Utilities

  Volts Phase Cycle
  PSI

Other Conditions

Describe other operating conditions or requirements which would be helpful to the proper application of this equipment (i.e., automation level required, budgetary restrictions, etc.)

contact-clo

Brief Introduction
This is a complete line to produce vehicle license plates, it include 2 parts equipment. One part is blank stamping line to make semi-finished product, the other part’s machines are used to process semi-product.

Comprising of the line:
1. Pneumatic press: 1set
2. Stamping dies for blanking semi-product: 1set
3. Decoiler: 1set
4. Straightener with plastic film covering device: 1set
5. NC servo roll feeder: 1set
6. Conveyor bet: 1set
7. Scrap recoiler: 1set
8. Number plate hydraulic embossing machine with number&word mould+hot stamping machine: 1set

Main features of the car license plate blanking line are as follows
1. For number plate blanking line. Strip were paid off by decoiler, next strips were cleaned&dried by cleaning machine(OPTIONAL PART), next strips were flat and coated with plastic covering device, next strips were blanked by power press, at last products were collected at the conveyor beit meanwhile scrap strips were collected in scrap coil.
2. Work pieces were processed by embossing machine, at last processed by hot stamp machine.

 

top