contact us


Quote Form



* If Quote is requested these Fields are Required.

A. Material

Thickest - Width x Thickness
Thinnest - Width x Thickness
Widest - Width x Thickness
Narrowest - Width x Thickness
Tensile PSI
Yield PSI
Shear PSI

B. Coils

Minimum :
Maximum :
Minimum :
Maximum :

C. Press

Maximum SPM:
Minimum SPM: (Give Minimum SPM at which tonnage can be maintained.)

D. Dies

Maximum :
Minimum :
Maximum :
Minimum :

E. Application

Maximum :
Minimum :
  SPM at Inch Length
  Feet Per Minute

(as you face the press)

Length Width Deep

F. Equipment Desired

1. Servo Feed
2. Straightener
3. Stock Reel
4. Coil Loading Car
5. Coil Cradle
6. Coil Loading Ramp
7. Hold Down Peeler
8. Threading Table
9. Central Control Console
10. Straightener Feeder
11. Straightener Feeder
12. Cradle Straightener Feeder
13. Other - Describe

G. Plant Utilities

  Volts Phase Cycle

Other Conditions

Describe other operating conditions or requirements which would be helpful to the proper application of this equipment (i.e., automation level required, budgetary restrictions, etc.)


Brief Introduction
There are 2 sets of 3 in 1 decoiler straightener feeder NCHW3-600A and NCHW3-800A have been running well in Yutong factory, the first-rate bus manufacturer in China. They are suitable for high tensile steel, stainless steel, low carbon steel, whose thickness ranges from 1.0 to 6.0mm.

Main features of 3 in 1 decoiler straightener feeder

1. It is equipped with material tips assist entrance device. It is convenient to guide and insert strip head into straightener part automatically. No need man power to insert strip head manually. 

2. It is also equipped with flip-top device. It can open some angle of straightening feeder part driven by hydraulic cylinders, convenient to clean straightening rolls.